VeEX MPA User Manual page 703

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
VLAN TPID
VLAN PCP/QOS
VLAN DEI
VLAN VID
Prev
Next
703
MPLS Tagging must be enabled to use this parameter.
Configures the VLAN Tag Protocol Identifier. The default value is
0x8100, but the menu lets you select 0x88A8, 0x9100, 0x9200 or
enter a 2-byte User Defined HEX value.
VLAN Tagging must be enabled to use this parameter
Configures the VLAN Priority Code Point/Quality Of Service. This
is the frame's priority level and is a 3-bit field ranging from the
default value of 0 (best effort) to 7 (highest priority).
VLAN Tagging must be enabled to use this parameter.
Configures the VLAN Drop Eligible Indicator. This is a 1-bit
setting that should remain set to the default value of 0, for
Ethernet networks.
VLAN Tagging must be enabled to use this parameter.
Assigns a VLAN ID to the VLAN tag. This identifies to which
VLAN the frame belongs. IDs are entered as a decimal identifier
ranging from 0 to 4095.
VLAN Tagging must be enabled to use this parameter.
Moves to the stream with the next lower number.
If currently looking at stream #1, selecting "Prev" will bring up
stream #32. Note that changes made will not be saved until
"Save All" is selected.
Moves to the stream with the next higher number.
If currently looking at stream #32, selecting "Next" will bring up
stream #1. Note that changes made will not be saved until "Save
All" is selected.