Safety Guidelines - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00

Safety Guidelines

The instrument has been designed to ensure safe operation, however, please observe
all warnings, cautions, and instructions marked on the product and included in this
document. The following safety precautions are provided to avoid personal injury and
prevent damage to this product or any products connected to it during installation and
normal operation. Safety precautions should be observed during all phases of operation
of this instrument. VeEX Inc. assumes no liability for the customer's failure to comply
with safety precautions and requirements.
•
Environmental Safety : This product may contain lead-based solder materials and
a lithium battery for computer support. Please return all VeEX products to the
factory for proper disposal. Operation of this product is not hazardous to the
environment.
This is a Class A product per EN55022. In a domestic environment, this product
may cause radio interference in which case the user may be required to take
adequate measures.
•
Do Not Operate in Hazardous Conditions: This instrument is not intended for
outdoor use. To avoid injury or fire hazard, do not operate this instrument in wet,
damp, or other hazardous conditions. Do not operate this instrument in the
presence of flammable gases or fumes or in an explosive or combustible
environment.
•
ESD: Always wear an ESD wrist strap and follow appropriate
installing or servicing the unit and its components.
•
Air Flow: To ensure proper air flow and cooling, always make sure that the test
modules are properly installed into the correct slot locations. An empty slot should
never be exposed. Always have an empty slot covered by the appropriate blank
faceplate when a circuit pack is removed for any period of time.
•
Laser Safety: The unit contains Class 1 laser devices. CDRH Accession No.
0021615. When fiber is not attached to the optical ports, always leave protective
covers on optical connectors to prevent damage and prevent laser emissions.
General Information
ESD procedures when
12