Protocol Sip - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Call Admission Controller (CAC)

PROTOCOL SIP

protocol sip {bandwidth|call-threshold <1-500>}
D
ESCRIPTION
This command is entered in the Admission Control CAC Object Configuration
mode.
This command is used to configure protocol type, bandwidth, limit for the number
of active calls in a CAC object. When bandwidth is configured, bandwidth
information is obtained from the corresponding egress QoS policy.
Note: Currently, CAC is supported only for SIP calls.
P
ARAMETERS
bandwidth
1-500
D V
EFAULT ALUE
None.
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config-ac-cac-mycac)# protocol sip bandwidth call-threshold
10
R H
ELEASE ISTORY
Release 2.3: command was introduced.
748
Beta
Parameter
Alcatel-Lucent
Description
When bandwidth is configured for CAC,
calls are allowed depending on the
bandwidth availability.
When call threshold is configured for CAC,
calls are allowed depending on the number
of active calls on that interface.
OmniAccess 700 CLI Command Reference Guide
Beta