Match Interface; Match Ip Address - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

MATCH INTERFACE

match interface <interface-name>
D
ESCRIPTION
Enter this command in the Route-Map Configuration mode. This command
matches the specified next hop route out of one of the interfaces specified.
P
ARAMETERS
Parameter
interface-name
D V
EFAULT ALUE
No match interfaces are defined.
E
XAMPLE
ALU(config-route-map)# match interface GigabitEthernet 7/0

MATCH IP ADDRESS

match ip address {<1-99>|<1300-2699>|<access-list name>|prefix-
list <prefix-list name>}
D
ESCRIPTION
This command is entered in the Route-map Configuration mode. This command is
used to match a destination network number address that is permitted by a
standard access list, an extended access list, or a prefix list, or perform policy
routing on packets.
P
ARAMETERS
Parameter
1-99
1300-2699
access-list name Name of a specific access list.
prefix-list-name Name of a prefix list.
D V
EFAULT ALUE
No access list numbers or prefix lists are specified.
E
XAMPLE
ALU(config-route-map)# match ip address prefix-list testprefix
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Name of the interface.
Standard IP access list number. The list defines which
networks are to be permitted or denied.
Extended IP access list number. The list defines which
networks are to be permitted or denied.
Alcatel-Lucent
Description
Description
Beta
match interface
353