Table of Contents
Advertisement
Transmit Delay
Designated Router
Backup Designated Router
Timer intervals configured
Hello
Neighbor Count
Message Digest Authentication
SHOW IP OSPF INTERFACE
show ip ospf interface-process [{GigabitEthernet|Serial} <slot/
port>|Loopback <0-14487>}]
D
ESCRIPTION
Enter this command in Super User mode or Router Configuration mode. This
command displays the interface-process table.
P
ARAMETERS
{GigabitEthernet|Serial}
<slot/port> Loopback <0-14487>
E
XAMPLE
ALU(config-router ospf 20)#show ip ospf interface-process
-------------------------------------------------------
Interface
GigabitEthernet7/0
GigabitEthernet7/0
loopback 9
loopback1
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
-
PROCESS
Parameter
Interface-Process Table:
Attached Process
20
20
-
-
Alcatel-Lucent
show ip ospf interface-process
Description
Interface transmit delay, interface state,
and router priority.
Designated router ID and respective
interface IP address.
Backup designated router ID and
respective interface IP address.
Configuration of timer intervals.
Number of seconds until next hello
packet is sent out this interface.
Count of neighbors and list of adjacent
neighbors on an interface.
Type of authentication enabled on an
interface.
Description
Interface name with its slot and port
number.
Waiting Process
-
-
-
-
Beta
497
Advertisement
Table of Contents
