Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 49

Left running head:
Chapter name (automatic)
Using the Command Line Interface
U M (UM)
SER ODE
You can start the CLI session from a console, SSH, or a Telnet connection. When
you start the CLI session, you are prompted for a user name / password
combination. When you enter the user name and password correctly, you will
automatically enter the UM. If you enter an incorrect password three consecutive
times, the CLI session will be closed.
Since UM is the basic administrative level, only a limited set of commands like
basic diagnostics, monitoring commands, ping, and ssh are available. The UM
command set is a subset of the SUM command set. UM is also the starting point
for accessing the SUM command set.
U M C S
SER ODE OMMAND
Command (in UM)
clear
enable
exit
help
logout
mping
mtrace
no
nslookup
ping
quit
service
show
ssh
telnet
terminal
traceroute
16
Beta
ET
Reset functions.
Turn on privileged commands.
Exit from current mode.
Description of the interactive help system.
Exit from the EXEC.
Multicast Ping.
Trace reverse multicast path from destination to
source.
Negate a command or set its defaults.
Translate a DNS name to an IP address or vice-
versa.
Send echo messages.
Quit this session.
Set terminal line parameters.
Show running system information.
Open a SSH connection.
Open a telnet connection.
Set terminal line parameters.
Trace route to destination.
Alcatel-Lucent
Description
OmniAccess 700 CLI Command Reference Guide
Beta