Dot1X Default; Dot1X Host-Mode - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
802.1X Port-Based Authentication
1
DOT X DEFAULT

dot1x default

D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is
used to reset the configurable 802.1X parameters to the default values.
P
ARAMETERS
None.
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-if switchport5/0)# dot1x default
1 -
DOT X HOST MODE
dot1x host-mode {multi-host|multi-auth}
D
ESCRIPTION
This command is entered in the Interface Configuration mode.
This command is used to allow multiple hosts (clients) or multiple authentication
on an 802.1X-authorized port. Make sure that the port-based authentication for
the specified L2 interface is set to 'auto'.
P
ARAMETERS
multi-host
multi-auth
D V
EFAULT ALUE
The default is single host mode.
E
XAMPLE
ALU(config-if switchport5/0)# dot1x host-mode multi-host
190
Beta
Parameter
Alcatel-Lucent
Description
Choose this keyword to allow multiple
hosts (clients) on an 802.1X-authorized
port.
Choose this keyword to allow multiple
authentication on an 802.1X-authorized
port.
OmniAccess 700 CLI Command Reference Guide
Beta