Lfi Configuration On Mlppp Cli Commands; Fragment Delay - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Link Fragmentation and Interleaving (LFI)
LFI C
ONFIGURATION ON
This section deals with the commands relevant to LFI configuration on MLPPP
interface.

FRAGMENT DELAY

fragment delay <1-256>
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is used
to configure the fragment delay on the MLPPP bundle interface.
P
ARAMETERS
1-256
D V
EFAULT ALUE
The default value of fragment delay is 0, i,e., no fragmentation will be performed.
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config)# interface mlppp 100
ALU(config-if mlppp100)# fragment delay 10
Note: The MTU (Maximum Transmission Unit) of the individual links in a MLPPP bundle
should be greater than the fragment size.
R H
ELEASE ISTORY
Release 2.3: command was introduced.
306
Beta
MLPPP CLI C
Parameter
Alcatel-Lucent
OMMANDS
Description
Fragment delay range (in milli seconds).
Fragment delay on the MLPPP interface
specifies how long it will take for a
fragment to exit the interface.
OmniAccess 700 CLI Command Reference Guide
Beta