Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 67

Left running head:
Chapter name (automatic)
Using the Command Line Interface
I S C
NTERFACE HOW OMMANDS
T V D
O IEW THE ETAILS OF
Command (in SUM)
show interfaces [<name> <slot/
port:channel.subchannel>]
show interfaces brief
E 1
XAMPLE
ALU# show interfaces GigabitEthernet 7/0
GigabitEthernet7/0 is up, line protocol is down
Hardware is Intel 82546, address is 0011.8b00.86a8
(0011.8b00.86a8)
Internet address is 172.16.2.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation ARPA,
Auto-duplex(Unknown), Auto(Unknown), 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0 (size/
max), 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
34
Beta
A I S
LL NTERFACES OR A PECIFIC
keepalive not set
Alcatel-Lucent
I
NTERFACE
Description
This command displays the information
of all the interfaces configured.
This command displays information for a
specific interface.
This command displays information of all
the IP and non-IP interfaces configured.
OmniAccess 700 CLI Command Reference Guide
Beta