Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 377

Left running head:
Chapter name (automatic)
Protocol Independent Features
Parameter
any
host <host-ip-
address>
<source-ip-
address/prefix-
length>|<source-
ip-address
subnet-mask>
operators
<destination-ip-
address/prefix-
length>|<destina
tion-ip-address
subnet-mask>
log
log-input
enable fragment
precedence [<0-
7>|<keywords>]
tos [<0-
15>|<keywords>
Example:
ALU(config-ext-nacl)# permit ip 24.0.0.0/8 25.0.0.0/8
ALU(config-ext-nacl)# deny ip any 13.0.0.0/8
344
Beta
Match any source or destination IP address.
Specify host IP address.
Source IP address network.
This is specific to UDP and TCP protocol.
Compares TCP/UDP ports of the source/destination ports.
When used after the source IP address/source-mask,
specifies a source port.
When used after the destination IP address/destination
mask, specifies a destination port.
Destination IP address network.
By default, log the message.
If access list is matched, log the message.
Enable access list matching for fragmented packets.
Match access list if specified precedence matches packet.
Match access list if specified ToS matches packet.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Description
Beta