Network Area; No Passive-Interface - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Open Shortest Path First

NETWORK AREA

network {<ip-address subnet-mask>|<ip-address/prefix-length>}
area {<0-4294967295>|<ip-address>}
D
ESCRIPTION
This command is used in the Router Configuration mode. Enables routing on an
IP network and the area ID for that interface.
Note: Area '0' is called the backbone area.
P
ARAMETERS
Parameter
<ip-address
subnet-mask|<ip-
address/prefix-
length>
area <0-
4294967295>
area <ip-
address>
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-router ospf 30)# network 10.0.0.0/8 area 1
-
NO PASSIVE INTERFACE
no passive-interface {{GigabitEthernet|Serial} <slot/
port>|Loopback <0-14487>|default}}
The "no" command enables sending of hello packets and routing updates on a
specified interface.
476
Beta
IP address with subnet mask or prefix length.
Area ID that is to be associated with the OSPF address
range. It can be specified as either a decimal value or as an
IP address. If you intend to associate areas with IP subnets,
you can specify a subnet address as the value of the area-id
argument.
OSPF area ID in IP address format.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Description
Beta