Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 426

loopback1
Routing for Networks:
1.0.0.0
4.0.0.0
Routing Information Sources:
Gateway
1.1.1.1
Distance: (default is 120)
Field
Routing Protocol is
"rip"
Sending updates
every 30 seconds
next due in 2 seconds The precise time when the next update is due to be sent.
Invalid after 180
seconds
holddown for 180
flushed after 240
Outgoing update filter
list is not set for all
interfaces
Incoming update filter
list is not set for all
interfaces
Redistributing
Default version
control
Routing for Networks
Routing Information
Sources
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
2 2
Interface
GigabitEthernet7/1
Specifies the routing protocol used.
Specifies the time between sending updates.
Specifies the value of the invalid parameter.
Specifies the current value of the holddown parameter.
Specifies the time (in seconds) after which the individual
routing information will be flushed out.
Specifies whether the outgoing filtering list has been set.
Specifies whether the incoming filtering list has been set.
Lists the protocol that is being redistributed.
Specifies the version of RIP packets that are sent and
received.
Specifies the networks for which the routing process is
currently injecting routes.
Lists all the routing sources that the software is using to
build its routing table. For each source, you will see the
following displayed:
•
IP address
•
Administrative distance
•
Time the last update was received from this source
Alcatel-Lucent
show ip protocols
Distance Last Update
115 00:00:00
Description
Beta
393