Left running head:
Chapter name (automatic)
T1E1 Line Card
MTU
mtu <64-1500>
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is
used to configure the MTU value on the serial interface, i.e., the maximum size of
the transmitted layer 2 payload.
P
ARAMETERS
64-1500
D
V
EFAULT
ALUE
The default MTU is 1500 Mbps.
E
XAMPLE
ALU(config-if Serial 0/0:0)# mtu 1200
NO CLOCKSOURCE
no clocksource
The "no" keyword sets the clocksource to its default. The default value for
clocksource is internal.
NO CHANNEL GROUP
no channel-group <0-23>
This command removes the channel groups configured on the E1 controller. The
default speed is 64 Kbps.
NO ENCAPSULATION
no encapsulation
The "no" command restores the encapsulation to its default. The default is HDLC.
NO FRAMING
no framing
The "no" command resets the framing value to its default. The default framing
value is crc4 for E1.
216
Beta
Parameter
Alcatel-Lucent
Description
Size of packet in bytes in the range 64 -
1500.
OmniAccess 700 CLI Command Reference Guide
Beta