Left running head:
Chapter name (automatic)
Common Classifiers
LIST
list <name> {host <ip-address>...|include <list-
name>...|interface <name>...|prefix <ip-address/prefix-
length>...
D
ESCRIPTION
This command is used to configure lists, which can be used within match-lists.
P
ARAMETERS
Parameter
list <name>
host <ip-
address>...
include <list-
name>...
interface
<name>...
prefix <ip-
address/prefix-
length>...
D
V
EFAULT
ALUE
IP is the default protocol.
E
XAMPLE
E
1:
X
Lists may also include other lists by referencing the other list's name, effectively
extending the list by combining the elements in the other list as shown below:
ALU(config)# list l1 interface GigabitEthernet 3/0 interface
GigabitEthernet 7/0
ALU(config)# list l2 prefix 10.0.0.0/8 prefix 20.0.0.0/8
ALU(config)# list Zone1 list l1 list l2
322
Beta
Description
Name of the list configured.
Host addresses that are to be grouped.
List names to be concatenated with the present list
configured.
Interfaces to be grouped (Only GigabitEthernet is supported
in the current release).
Networks to be grouped.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta