NO ENCAPSULATION
no encapsulation {frame-relay|ppp|mlppp|mlfr}
D
ESCRIPTION
This command is entered in the Interface Configuration mode.
This command is used to configure encapsulation on the interface to HDLC. This
command is applicable only if the encapsulation is already set to Frame Relay or
PPP.
P
ARAMETERS
frame-relay
ppp
mlppp
mlfr
E
XAMPLE
ALU(config-if Serial0/0:0)# no encapsulation frame-relay
NO HDLC KEEPALIVE
no hdlc keepalive
This command resets the keepalive interval to its default, which is 10 seconds.
SHOW INTERFACE
show interfaces Serial [<slot/port:channel>]
D
ESCRIPTION
Use this command to verify if HDLC is the current encapsulation on the interface,
and to check the interface details.
P
ARAMETERS
serial
<slot/port:channel>
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Parameter
Alcatel-Lucent
Description
Frame-relay encapsulation.
Point to Point Protocol encapsulation.
Multilink Point to Point encapsulation.
Multilink Frame-relay encapsulation.
Description
Type of interface.
Interface number with slot/port and
channel group number.
Beta
no encapsulation
247