Pppoe Service-Name - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Point-to-Point Protocol over Ethernet (PPPoE)
PPPOE SERVICE
pppoe service-name <name>
D
ESCRIPTION
Enter this command in the Interface Configuration Mode.
This command is used to configure the PPPoE client to request a particular
service (e.g. web-access) supported by the PPPoE server.
P
ARAMETERS
name
D V
EFAULT ALUE
None.
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# pppoe service-name ISP1
Note: Service name can be of maximum length 50 characters.
The PPPoE service-name configured on OA-700 should match the service-name
supported on the server.
If "service-name" is not configured, then the client accepts any service offered by the
PPPoE server.
R H
ELEASE ISTORY
Release 2.3: command was introduced.
286
Beta
-
NAME
Parameter
Alcatel-Lucent
Description
Service name supported by the PPPoE
server.
OmniAccess 700 CLI Command Reference Guide
Beta