Ip Community-List (Standard) - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Protocol Independent Features
-
IP COMMUNITY LIST
ip community-list <1-99> {deny|permit} [<1-4294967295>|
<AA:NN>|internet|local-AS|no-advertise|no-export]
D
ESCRIPTION
Enter this command in the Configuration mode. This command is used to
configure a Standard Community-list. Creates a community-list for BGP, and
controls access to it.
P
ARAMETERS
Parameter
1-99
deny
permit
1-4294967295
AA:NN
internet
local-AS
no-advertise
no-export
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config)# ip community-list 1 permit internet
348
Beta
( )
STANDARD
Standard community list number.
Denies access for matching conditions.
Permits access for matching conditions.
Community number.
Community number in aa:nn format.
If this attribute is set, router advertises this route to all the
BGP peers.
If this attribute is set, router advertises this route to all the
BGP peers in the same autonomous system.
If this attribute is set, router does not advertise this route to
any BGP peers.
Specifies that the routes with this community attribute will
not be advertised to any EBGP peer.
Alcatel-Lucent
Description
OmniAccess 700 CLI Command Reference Guide
Beta