Match-List; Match-Lists (Rulesets) - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Common Classifiers
-
MATCH LIST
match-list <name>
D
ESCRIPTION
This command is used to configure a match-list. This enters Match-list
Configuration mode.
P
ARAMETERS
name
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config)# match-list test
ALU(config-match-list-test)#
- (
MATCH LISTS RULESETS
A complete specification for rule is as follows:
This command is used to configure a rule for protocols like IP, TCP, UDP, etc. You
can define a rule with subnets, host addresses, or interfaces or list of any of them.
[<1-65535>] [<protocol>] [<source>] [<destination>] [from <port
number>] [to <port number>]] [<fields to be matched>]
The following command is used to configure rules for IP in a match-list.
[<1-65535>] ip {any|host <source ip-address>|interface
<name>|list <name>|prefix <source ip-address/prefix length>}
{any|host <destination ip-address>|interface <name>|list
<name>|prefix <destination ip-address/prefix length>} [dscp
{<0-63>|<dscp-mnemonics>}|fragment|ip-precedence {<0-
7>|<precedence-mnemonics>}|length {<1-1500>
|{eq|ge|gt|le|lt|range <1-1500>}}|tos {<0-15>|<tos-
mnemonics>}|type {ftp|normal|rpc|sip|tftp}]
324
Beta
Parameter
)
Alcatel-Lucent
Description
Name of the match-list being configured.
OmniAccess 700 CLI Command Reference Guide
Beta