Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 52

C M
ONFIGURATION ODE
From SUM, you can enter the Configuration Mode (CM). The CM is used to
configure the system globally to enter specific configuration modes or to configure
specific elements, such as interfaces or protocols.
In this mode, you can enter the commands that configure general system
characteristics. CM allows you to make changes to the running configuration. If
you later save the configuration, these commands are stored across router
reboots. To access CM, enter the following command in SUM:
configure terminal
E
XAMPLE
ALU#configure terminal
ALU(config)#
Enter configuration commands, one per line. End with CNTL/Z.
To exit the Configuration mode and return to the SUM, enter the Control-Z
command.
ALU(config)#^Z
ALU#
CM C S
OMMAND ET
aaa
access-list
arp
auto
banner
class-map
clear
clock
controller
crypto
customized-service
OmniAccess 700 CLI Command Reference Guide
Beta
(CM)
Command (in CM)
Command (in CM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Enters Configuration mode
Description
Authentication, Authorization and
Accounting
Add an access list entry
ARP setting
Create Auto-QoS template
Define a login banner
Set QoS Class Map.
Terminating the Session
System clock settings
Select a controller to configure
IPSEC VPN module
Customize services
Introduction to CLI Modes
19
Beta