Loopback; No Cablelength; No Clocksource - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
T1E1 Line Card

LOOPBACK

loopback {local|network {line|payload}|remote {line|payload}}
D
ESCRIPTION
This command is used in the Controller Configuration mode. Use the loopback
controller configuration command to put the T1 or E1 line into loopback mode. It
can be used to verify connectivity.
P
ARAMETERS
Parameter
local
line
payload
remote
D V
EFAULT ALUE
Loopback is disabled by default for T1 lines.
E
XAMPLE
The following configuration establishes a loopback of the incoming E1 signal on
controller T1 0:
ALU(config)#controller T1 1/0
ALU(config-controller T1)# loopback network line

NO CABLELENGTH

no cablelength
This command is used to restore the value to its default.

NO CLOCKSOURCE

no clocksource
The "no" keyword sets the clocksource to its default.
230
Beta
Description
The controller loops the internal signal back to the
internal bus.
The controller loops the external line signal back
towards the network without reframing the signal.
The controller loops the external line signal back
towards the network and reframes the signal.
The T1 controller sends the inband loop-up code to the
remote device. The remote device detects the code
and loops the line back.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta