Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 532

E 3
XAMPLE
ALU# show ip ospf neighbor detail
Neighbor 1.1.1.1, interface address 1.1.1.1
In the area 0 via interface GigabitEthernet7/0
Neighbor priority is 1, State is FULL, 19 state changes
DR is 1.1.1.2 BDR is 1.1.1.1
Options is 0x42
Dead timer due in 00:00:31
Neighbor is up for 00:49:28
retransmission queue length 0, number of retransmissions 1
Neighbor 6.6.6.6, interface address 2.2.2.1
In the area 1 via interface GigabitEthernet7/1
Neighbor priority is 1, State is FULL, 10 state changes
DR is 2.2.2.2 BDR is 2.2.2.1
Options is 0x42
Dead timer due in 00:00:35
Neighbor is up for 00:31:32
retransmission queue length 0, number of retransmissions 0
Neighbor
Interface address
In the area
Neighbor priority
State changes
DR is
BDR is
Options
Dead timer due in
Neighbor is up for
retransmission queue length
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Alcatel-Lucent
show ip ospf neighbor
Description
Neighbor router ID.
IP address of the interface.
Area and interface through which the
OSPF neighbor is known.
Router priority of the neighbor, neighbor
state.
Number of state changes since the
neighbor was created. This value can be
reset using the 'clear ip ospf counters
neighbor' command.
Router ID of the designated router for
the interface.
Router ID of the backup designated
router for the interface.
Hello packet options field contents.
Expected time before the router declares
the neighbor dead.
Number of hours:minutes:seconds since
the neighbor went into two-way state.
Number of elements in the
retransmission queue. Number of times
update packets have been resent during
flooding.
Beta
499