No Ppp Timeout Max-Failure; No Ppp Timeout Max-Terminate; No Ppp Timeout Restart-Interval; No Ppp Timeout Restart-Timer - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Point to Point Protocol
NO PPP TIMEOUT MAX

no ppp timeout max-failure

The "no" command sets the max-failure value to its default, 5 seconds.
NO PPP TIMEOUT MAX

no ppp timeout max-terminate

The "no" command sets the max-terminate value to its default, i.e., 2 seconds.
NO PPP TIMEOUT RESTART

no ppp timeout restart-interval

The "no" command sets the LCP/NCP restart-interval to its default, i.e., 30
seconds.
NO PPP TIMEOUT RESTART

no ppp timeout restart-timer

The "no" command resets the restart-timer to its default, i.e., 3 seconds.

PPP AUTHENTICATION

ppp authentication {pap|chap|eap}
D
ESCRIPTION
This command enables you to configure an authentication protocol for
authenticating the peer.
P
ARAMETERS
pap
chap
eap
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp authentication pap
262
Beta
-
FAILURE
-
TERMINATE
-
INTERVAL
-
TIMER
Parameter
Alcatel-Lucent
Description
Password Authentication Protocol.
Challenge Authentication Protocol.
Extensible Authentication Protocol.
OmniAccess 700 CLI Command Reference Guide
Beta