Source Nat (Snat) Configuration Commands; Source-Nat - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Network Address Translation
S N (SNAT) C
OURCE AT
-
SOURCE NAT
[<1-65535>] match [{all|any}] <match-list name> source-nat
D
ESCRIPTION
Enter this command in the NAT configuration mode. This command is used to
configure a SNAT, and configure one or more rule (associate match-lists and set
priority for the rule) for the configured SNAT.
P
ARAMETERS
Parameter
1-65535
match [{all|any}]
<match-list name>

source-nat

D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-nat-N1)# 10 match m1 source-nat
572
Beta
C
ONFIGURATION
The range for the NAT policy rule. This rule number
signifies the priority of a rule.
This command forms a match-list of the Common
Classifiers that are pre-configured. In this type of match,
the relevant action is performed even if one rule in the
list is satisfied.
Type of NAT, here it is the SNAT.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
OMMANDS
Description
Beta