T1 Cli Commands; Cablelength Long - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

T1 CLI C
OMMANDS
The following section gives a succinct overview on the commands that are used
only on the T1 controller.

CABLELENGTH LONG

cablelength long {-15db|-22.5db|-7.5db|0db}
D
ESCRIPTION
This command is used in the Controller Configuration mode. This command is
used to configure transmit and receive levels for a cable length (line build-out)
longer than 660 ft for a T1 trunk.
P
ARAMETERS
Parameter
-15db
-22.5db
-7.5db
0db
D V
EFAULT ALUE
Cablelength of long 0 db is the default for the T1 cards.
E
XAMPLE
The following example changes transmit attenuation of controller T1 of slot 0 and
port 0 to appropriate level for long cables:
ALU(config-controller)# cablelength long -22.5db
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Sets the receive sensitivity to -15db if the hardware
has configurable receive sensitivity.
Sets the receive sensitivity to -22.5db if the hardware
has configurable receive sensitivity.
Sets the receive sensitivity to -7.5 dB if the hardware
has configurable receive sensitivity.
Sets the receive sensitivity to 0 dB if the hardware
has configurable receive sensitivity.
Alcatel-Lucent

T1 CLI Commands

221
Beta