Debug Firewall; Ip Filter - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Filter and Firewall

DEBUG FIREWALL

debug firewall
{session|filter|nat|attack|alg|intrusion|selector [saddr <ip-
address>|daddr <ip-address>|protocol <number>|sport <number> |
dport <number>][output|permanent]|all [detail-level]}
D
ESCRIPTION
Enter this command in the Filter Configuration mode. This command turns on
debugging for the filter statistics configured. The "selector" keyword is used to
debug only selected traffic.
P
ARAMETERS
saddr <ip-address>
daddr <ip-address>
protocol <number>
sport <number>
dport <number>
E
XAMPLE
The example below enables debugging for the source IP 10.91.0.52
ALU# debug firewall selector saddr 10.91.0.52

IP FILTER

ip filter <name>
D
ESCRIPTION
Enter the IP Filter command in the Configuration mode. This command configures
a filter and enters the Filter Configuration mode.
P
ARAMETERS
name
E
XAMPLE
The Example below configures the IP filter f1
ALU(config)# ip filter f1
ALU(config-filter-f1)#
592
Beta
Parameter
Parameter
Alcatel-Lucent
Description
Source address.
Destination address.
Protocol.
Source port number.
Destination port number.
Description
Name for the filter being configured.
OmniAccess 700 CLI Command Reference Guide
Beta