Offset-List - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
OFFSET LIST
offset-list {{<0-99>|<1300-1999> <access-list name>} {in|out}}
{<0-16>} [<interface-name>]
D
ESCRIPTION
Enter the offset-list command in the Router Configuration mode. This command
applies an offset to the incoming and outgoing routing metrics.
P
ARAMETERS
Parameter
0-99
1300-1900
access-list name
in
out
0-16
interface-name
D V
EFAULT ALUE
Disabled.
E
XAMPLE
ALU(config)#access-list 1 permit 10.33.0.0 0.0.0.0
ALU(config)#router rip
ALU(config-router)#network 192.168.1.0
ALU(config-router)#network 10.0.0.0
ALU(config-router)#offset-list 1 in 2 Serial0/0:1
The syntax of the offset-list says "Examine RIP advertisements incoming from
interface Serial0/0:1. For route entries matching the addresses specified in
access-list 1, add 2 hops to the metric."
If no interface is identified, the list will modify either all incoming updates or all
outgoing updates specified by the access-list on any interface.
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Access list number. '0' selects all networks.
Extended Access list number (expanded range).
Access-list name.
Applies the access list to incoming metrics.
Applies the access list to outgoing metrics.
Positive offset (0-16) to be applied to metrics for networks
matching the access list. If the offset is 0, no action is
taken.
Interface to which the offset list is to be applied.
Alcatel-Lucent

offset-list

389
Beta