Ip Ospf Retransmit-Interval; Ip Ospf Transmit-Delay - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

IP OSPF RETRANSMIT
ip ospf retransmit-interval <1-65535>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
specifies the time (in seconds) between LSA retransmissions for adjacencies
belonging to an OSPF interface.
P
ARAMETERS
Parameter
1-65535
D V
EFAULT ALUE
The default retransmit-interval is 5 seconds.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf retransmit-
interval 6
IP OSPF TRANSMIT
ip ospf transmit-delay <1-65535>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command sets
the estimated time in seconds required to send a link-state update packet on an
OSPF interface.
P
ARAMETERS
Parameter
1-65535
D V
EFAULT ALUE
The default transmit-delay is 1 second.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf transmit-delay 2
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
-
INTERVAL
Time (in seconds) between retransmissions. It must be
greater than the expected round-trip delay between any two
routers on the attached network.
-
DELAY
Time (in seconds) required to send a link-state update. The
default is 1 seconds.
Alcatel-Lucent

ip ospf retransmit-interval

Description
Description
Beta
473