Mtu; No Clockrate; No Crc; No Invert-Txc - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Universal Serial Port (USP) Line Card

MTU

mtu <64-1500>
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is
used to configure the MTU value on the serial interface, i.e., the maximum size of
the transmitted layer 2 payload.
P
ARAMETERS
64-1500
D V
EFAULT ALUE
The default MTU is 1500 Mbps.
E
XAMPLE
ALU(config-if Serial 0/0:0)# mtu 1200

NO CLOCKRATE

no clockrate {64000|128000|256000|512000|1024000|2048000}
The "no" command sets the clock rate to default 64000 bps.

NO CRC

no crc {16|32}
The "no" keyword sets the CRC value to default 16.
-
NO INVERT TXC

no invert-txc

The "no" command will set the clock to the original phase.

NO LOOPBACK

no loopback
The "no" command removes the loopback configured on the interface.
240
Beta
Parameter
Alcatel-Lucent
Description
Size of packet in bytes in the range 64 -
1500.
OmniAccess 700 CLI Command Reference Guide
Beta