Set Origin; Set Weight - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

SET ORIGIN

set origin {igp|egp <1-65535>|incomplete}
D
ESCRIPTION
Enter this command in the Route-Map Configuration mode. This command sets
the BGP origin code.
P
ARAMETERS
Parameter
igp
egp <1-65535>
incomplete
D V
EFAULT ALUE
For redistributed routes, origin is set to incomplete. For routes learned from IGP
protocol, origin is set to IGP. The routes learned from EBGP, route origin is set to
EGP.
E
XAMPLE
ALU(config-route-map)# set origin incomplete

SET WEIGHT

set weight <0-4294967295>
D
ESCRIPTION
Enter this command in the Route-Map Configuration mode. Use this command to
weight of route.
BGP has weight attribute. If the same route is received from multiple routers, then
weight is used to give preference to some route. Route with highest weight is
preferred.
P
ARAMETERS
Parameter
0-4294967295
D V
EFAULT ALUE
Default weight is 0.
E
XAMPLE
ALU(config-route-map)# set weight 10
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Set Interior Gateway Protocol as origin attribute.
Set Exterior Gateway Protocol as origin attribute.
Unknown origin.
Weight value.
Alcatel-Lucent
Description
Description
Beta
set origin
367