Ip Dhcp Relay; Ip Dhcp Relay Interface - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
DHCP (Dynamic Host Configuration Protocol) Relay

IP DHCP RELAY

ip dhcp relay <dhcp server ip-address>
D
ESCRIPTION
This command is entered in the Interface Configuration mode.
This command is used to configure the DHCP server to which the DHCP requests
are to be forwarded. This command sets up the relays for packets received on a
given interface. A maximum of four DHCP relays can be configured on an
interface.
P
ARAMETERS
dhcp server ip-address
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay 192.168.1.1

IP DHCP RELAY INTERFACE

ip dhcp relay interface <interface-name>
D
ESCRIPTION
This command is entered in the Interface Configuration mode.
This command is used to configure the interface through which the DHCP relay
requests have to be rebroadcasted.
P
ARAMETERS
interface-name
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay interface
GigabitEthernet 3/1
848
Beta
Parameter
Parameter
Alcatel-Lucent
Description
IP address of the DHCP server.
Description
The interface through which the DHCP relay
requests have to be rebroadcasted.
OmniAccess 700 CLI Command Reference Guide
Beta