Show - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
L3 Interface Commands

SHOW

show
D
ESCRIPTION
This command is used in the Interface Configuration mode.This command
displays traffic on the GigE interface.
P
ARAMETERS
None.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)#show
GigabitEthernet7/0 is up, line protocol is up
Hardware is Intel 82546, address is 0011.8b00.2728
(0011.8b00.2728)
Internet address is 9.9.9.9/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 0 usec,
Loopback not set
Encapsulation ARPA,
Auto-duplex, 1000Mb/s, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0
(size/max), 0 drops
5 minute input rate 344 bits/sec, 1 packets/sec
5 minute output rate 8 bits/sec, 0 packets/sec
68 packets input, 5108 bytes, 0 no buffer
Received 39 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
3 packets output, 192 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
156
Beta
reliability 0/255, txload 0/255, rxload 0/255
Alcatel-Lucent
keepalive not set
OmniAccess 700 CLI Command Reference Guide
Beta