Ror-Keep-Alive-Message - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Telephony Services
- -
ROR KEEP ALIVE
ror-keep-alive-message {register|options} retry-count <1-6>
retry-after <30-3600>
D
ESCRIPTION
Enter this command in the Telephony Service Mode. This command is used to
configure the message type, message interval and the message count for the
keep alive message.
Note: If ROR does not get response for a keep alive message, then the keep alive will be
sent continuously (1-4 seconds). The configured 'retry after' value will be considered
only after getting the response for the keep alive.
Retry Count X Retry After determines the time before the call servers are declared
down.
P
ARAMETERS
register|options
1-6
30-3600
D V
EFAULT ALUE
The default message type is options. The default retry count is 1. The default retry
after is 60 seconds.
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(telephony-service)# ror-keep-alive-message register retry-
count 3 retry-after 30
R H
ELEASE ISTORY
Release 2.3: command was introduced.
758
Beta
-
MESSAGE
Parameter
Alcatel-Lucent
Description
Keep alive message type.
Specifies the number of continuous keep
alive messages ROR sends without
receiving a response from the call server,
before the call server is declared down.
Specifies the interval (in seconds) at which
the keep alive messages is to be
transmitted regularly to the call servers from
the ROR module.
OmniAccess 700 CLI Command Reference Guide
Beta