Port - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Network Address Translation

PORT

[<1-65535>] match [{all|any}] <match-list name> destination-nat
{host {<ip-address|host-name>}|pool <list-name>} port <1-65535>
D
ESCRIPTION
This command is used to configure port number for a DNAT.
P
ARAMETERS
Parameter
1-65535
match
[{all|any}]
<match-list
name>
destination-nat
ip-address
host-name
list-name
1-65535
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-nat-N2)# match m1 destination-nat host 192.168.10.91
port 100
ALU(config-nat-N2)# match m1 destination-nat pool l1 port 100
578
Beta
The range for the NAT policy rule. This rule number signifies
the priority of a rule.
This command forms a match-list of the Common
Classifiers that are pre-configured. In this type of match, the
relevant action is performed even if one rule in the list is
satisfied.
Type of NAT, here it is the DNAT.
The IP address of the host.
The host name.
The name of the list.
The port number for DNAT.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Description
Beta