Ip Access-List Extended - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
IP ACCESS LIST EXTENDED
ip access-list extended {<100-199>|<2000-2699>|<access-list-
name>}
D
ESCRIPTION
Enter this command in the Configuration mode. This command is used to define a
named access list, and enters Extended Access-list Configuration mode.
P
ARAMETERS
Parameter
<100-199>|<2000-
2699>
access-list-name Name of the access list.
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config)# ip access-list extended test
ALU(config-ext-nacl)#
Configure Extended IP Access-list Rule
This command is used to configure a rule for a Extended IP Access-List. You can
configure multiple rules for an IP access list.
{permit|deny} {igre|icmp|ip|ipinip|pim| rsvp|tcp|udp|<0-
255>} {any|host <host-ip-address>|<source-ip-address/prefix-
length>|<source-ip-address subnet-mask>} [operators]
{any|host <host-ip-address>|<destination-ip-address/prefix-
length>|<destination-ip-address subnet-mask>} [log] [log-
input] [enable fragment] [precedence [<0-7>|<keywords>] [tos
[<0-15>|<keywords>]]]
Parameter
permit
{igre|icmp|ip|ip
inip|pim|
rsvp|tcp|udp|<0-
255>}
deny
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
IP access list number.
Result is permit if conditions are matched.
Name or number of an Internet protocol. If a protocol is not
specified, the access-list entry applies to all protocols.
Result is deny if conditions are matched.
Alcatel-Lucent

ip access-list extended

Description
Description
Beta
343