Ip-Policy <Ip-Policy Name; No Ip-Policy; No Ip-Policy <Ip-Policy Name; No Rule - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Policy Based Routing
- < -
IP POLICY IP POLICY NAME
ip-policy <ip-policy name>
D
ESCRIPTION
Enter this command in the Interface Configuration mode. This command is used
to attach an IP policy to an interface.
Note: An interface can have only one IP policy applied on it at any time.
'Transparent-forwarding' command, if in effect, shall be cleaned up before this
command takes effect.
P
ARAMETERS
ip-policy name
E
XAMPLE
The following example binds the IP policy 'pbr1' to interface GigabitEthernet3/1.
ALU(config)# interface GigabitEthernet3/1
ALU(config-if GigabitEthernet3/1)# ip-policy pbr1
-
NO IP POLICY
no ip-policy <name> [force]
This command is used to delete an IP policy. If the policy is attached to any of the
interfaces, it cannot be deleted.
The "force" keyword will automatically detach the specified policy from respective
interfaces, and deletes the IP policy. This command when used also deletes all
the rules configured under this policy.
- <
NO IP POLICY IP
no ip-policy <ip-policy name>
This command detaches an IP policy attached to an interface.

NO RULE

no rule <1-65535>
This command is issued in the PBR Configuration mode. The command deletes a
rule corresponding to the rule number.
538
Beta
>
Parameter
- >
POLICY NAME
Alcatel-Lucent
Description
Name of the IP policy.
OmniAccess 700 CLI Command Reference Guide
Beta