Left running head:
Chapter name (automatic)
Using the Command Line Interface
Tunnel Specific Parameters:
Configured Source IP address 202.202.202.2,
Destination 201.201.201.2,
Key 0, Sequencing disabled, Checksum disabled,
df-bit reset, mode GRE
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/
max) 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0
abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Tunnel1 is up, line protocol is down
Internet address not set
MTU 1476 bytes, BW 1000000 Kbit, DLY 0 usec,
--More--
E
4
XAMPLE
ALU#show interfaces brief
Interface
switchport1/0
switchport1/1
switchport1/2
switchport1/3
switchport1/4
switchport1/5
switchport1/6
switchport1/7
GigabitEthernet7/0
GigabitEthernet7/1
Tunnel0
Tunnel1
Tunnel3
Tunnel5
mlppp1
36
Beta
Status
Down
Down
Down
Down
Down
Down
Down
Down
up
up
up
up
up
up
Down
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Protocol
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Down
Beta