Source-Nat Host - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
SOURCE NAT HOST
[<1-65535>] match [{all|any}] <match-list name> source-nat host
{<ip-address|host-name>} [port-range {<2048-65535> <2048-
65535>}|static]
D
ESCRIPTION
Enter this command in the NAT configuration mode. This command is used to
configure a SNAT with host IP address.
Note: If no address is configured, the IP address of the egress interface on which the NAT
policy is applied will be used.
P
ARAMETERS
Parameter
1-65535
match
[{all|any}]
<match-list
name>
source-nat
ip-address
host-name
Note: Currently, 'Hostname' option is not supported. Only host IP address can be
configured.
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-nat-N1)# match m1 source-nat host 192.168.10.91
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
The range for the NAT policy rule. This rule number signifies
the priority of a rule.
This command forms a match-list of the Common
Classifiers that are pre-configured. In this type of match, the
relevant action is performed even if one rule in the list is
satisfied.
Type of NAT, here it is the SNAT.
IP address of the host.
The host name.
Alcatel-Lucent
Description
Beta

source-nat host

573