Distribute-List - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Protocol Independent Features
-
DISTRIBUTE LIST
distribute-list {<1-199>|<1300-2699>|<access-list-name>|prefix
<prefix-list>} {in|out} {interface-name}
Enter the above command in Router Configuration mode. This command
permits or denies routes from being advertised in routing updates depending
upon the action listed in the access list.
distribute-list {<1-199>| <1300-2699>|gateway <ip-prefix-list
name> |prefix <ip-prefix-list name>} {in|out}
[[GigabitEthernet|Serial} <slot/port>|Loopback <0-14487>]
Enter the above command in Router Configuration mode. This command
suppresses networks from being advertised in routing updates. The distribute-
list in command is used to filter networks in received routing updates.
Note: The OA-700 does not support the Distribute-list feature in OSPF.
P
ARAMETERS
Parameter
1-199
1300-2699
access-list-name
prefix-list
ip-prefix-list name
in
out
GigabitEthernet|Ser
ial|loopback
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-router bgp AS1)#distribute-list 1 in GigabitEthernet
7/0
ALU(config-router rip)# distribute-list prefix prefix-example
in GigabitEthernet 7/0
342
Beta
Description
Standard IP access list number. The list defines which
networks are to be received and which are to be
suppressed in routing updates.
Extended IP access list number. The list defines which
networks are to be received and which are to be
suppressed in routing updates.
IP access list name.
Prefix list name.
IP prefix list name.
Applies the access list to incoming routing updates.
Applies the access list to outgoing routing updates.
Name of the interface.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta