Show Interfaces - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Switching on L2 Ports

SHOW INTERFACES

show interfaces
D
ESCRIPTION
•
This command if issued in the Configuration mode, displays the statistics of all the
interfaces including the information of all the L2 ports. The 'show' command if
issued in the Interface Configuration mode displays the statistics of only that
particular interface.
P
ARAMETERS
None.
E
XAMPLE
ALU(config-if switchport0/0)# show
switchport0/0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 0011.8b00.0e21
(0011.8b00.0e21)
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
loopback not set,
Auto-duplex, Auto, 1000BaseTx/Fx
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0(size/max),0 drops;Input queue 0/0(size/max), 0drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1950230 packets input, 722390067 bytes
Received 48676 broadcasts, 0 runts, 0 giants,0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun,0 ignored
0 watchdog, 14154 In multicast, 0 pause input
0 input packets with dribble condition detected
1971500 packets output, 842881406 bytes, 328 Sent broadcasts
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 Out multicast, 0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
166
Beta
Keepalive not set
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta