No Range; Range - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
DHCP (Dynamic Host Configuration Protocol) Server

NO RANGE

no range {<lower ip-address> <higher ip-address>|<automatic>}
Deletes a configured network range.

RANGE

range {<lower ip-address> <higher ip-address>|<automatic>}
D
ESCRIPTION
Enter this command in the DHCP Pool Configuration mode.
This command is used to configure the range of IP addresses within the network
of the pool, which are used to service DHCP requests from the clients.
Specification of range is mandatory for a network pool. The range cannot include
the network address and the broadcast address of the network.
Note: The network configuration for a pool must exist before a range can be specified.
P
ARAMETERS
<lower ip-address> <higher ip-
address>
automatic
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-dhcp-pool-p1)# range 1.2.3.50 1.2.3.100
ALU(config-dhcp-pool-p1)# range automatic
836
Beta
Parameter
Alcatel-Lucent
Description
Lower and the upper addresses of the
network range.
Specify entire network addresses to be
available to the client.
OmniAccess 700 CLI Command Reference Guide
Beta