No Ip Unnumbered; Passive-Interface; Passive-Interface Default - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Protocol Independent Features

NO IP UNNUMBERED

no ip unnumbered <interface-name> <slot/port>
Enter this command in the Interface Configuration mode. This command is used
to unconfigure the unnumbered interface.
-
PASSIVE INTERFACE
passive-interface <interface-name>
D
ESCRIPTION
Enter this command in the Router Configuration mode. This command
suppresses sending of routing updates through the specified interface.
P
ARAMETERS
Parameter
interface-name
D V
EFAULT ALUE
Routing updates are sent on the interface.
E
XAMPLE
ALU(config-router ospf1)#passive-interface GigabitEthernet 7/0
-
PASSIVE INTERFACE DEFAULT

passive-interface default

D
ESCRIPTION
Enter this command in the Router Configuration mode. This command sets all
interfaces as passive by default.
P
ARAMETERS
Parameter
default
D V
EFAULT ALUE
By default, all interfaces are active.
E
XAMPLE
ALU(config-router ospf1)# passive-interface default
358
Beta
Name of the interface.
All interfaces become passive.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Description
Description
Beta