Ip Unnumbered - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

IP UNNUMBERED

ip unnumbered <interface-name> <slot/port>
D
ESCRIPTION
This command is used in the Interface Configuration
This command is used to configure an interface to be an unnumbered interface
and associate a numbered IP interface with it. Use of this command results in the
IP address being shared by two interfaces.
P
ARAMETERS
Parameter
interface-name
<slot/port
D V
EFAULT ALUE
None.
E
XAMPLE
Configuring a Serial Interface to be an unnumbered interface. The IP address
configured on the GigabitEthernet 7/0 interface is also assigned to the interface
Serial 0/0:0, and both interfaces involved function normally.
ALU(config)# interface serial 0/0:0
ALU(config-serial-0/0:0)# ip unnumbered GigabitEthernet 7/0
Configuring Ethernet as an unnumbered interface throws up an error:
ALU(config)# interface GigabitEthernet 7/0
ALU(config-serial-0/0:0)# ip unnumbered Loopback 0
Point-to-point interfaces only
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Name of another interface in the system that has an IP
address, not another unnumbered interface.
Alcatel-Lucent
mode.
Description
Beta
ip unnumbered
351