Frame Relay Lmi Type - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

FRAME RELAY LMI TYPE

frame-relay lmi-type {ansi|q933a}
D
ESCRIPTION
This command is entered in Interface Configuration mode. This command is used
to set the LMI type to either ANSI or Q933A.
P
ARAMETERS
ansi
q933a
D V
EFAULT ALUE
The default LMI type is auto-sense.
Note: LMI Autosense is activated by default as the system acts as a DTE. The LMI
autosense will be activated when the physical interface is up and LMI type is not
configured on that interface.
E
XAMPLE
ALU(config-if mlfr100)# frame-relay lmi-type ansi
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Alcatel-Lucent
Description
American National Standards Institute
T1.617 Annex D.
ITU-T Q.933 Annex A.
Beta
frame relay lmi type
297