Ip Igmp Last-Member-Query-Interval; Ip Igmp Query-Interval - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
IP IGMP LAST MEMBER
ip igmp last-member-query-interval <100-65535>
D
ESCRIPTION
Enter this command in the Interface Configuration mode. Use this command to
configure the last-member query interval (in milliseconds) for the IGMP.
P
ARAMETERS
Parameter
100-65535
D V
EFAULT ALUE
The default last-member-query-interval is 1000 milliseconds.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp last-member-query-
interval 2000
-
IP IGMP QUERY
ip igmp query-interval <1-65535>
D
ESCRIPTION
Enter this command in the Interface Configuration mode. This command is used
to configure the interval (in seconds) at which the IGMP router sends query
messages on an interface.
P
ARAMETERS
Parameter
1-65535
D V
EFAULT ALUE
The default query-interval is 125 seconds.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp query-interval
100
OmniAccess 700 CLI Command Reference Guide
Beta
- -
QUERY INTERVAL
Denotes the time the router waits for the membership report
after sending membership query.
INTERVAL
Denotes the interval at which the IGMP router sends IGMP
general query messages.
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

ip igmp last-member-query-interval

Description
Description
527
Beta