Left running head:
Chapter name (automatic)
Point-to-Point Protocol over Ethernet (PPPoE)
PPPOE NEGOTIATE
pppoe negotiate
D
ESCRIPTION
Enter this command in the Interface Configuration Mode. This command is used
to initiate the PPPoE negotiation on the interface. This command helps to
terminate the existing PPPoE session, if any, and re-negotiate the session.
Note:
PPPoE negotiation is automatically started when the link is administratively brought
up on a PPPoE interface. It starts off by sending a PADI.
Also, whenever "encapsulation pppoe" is configured on an administratively up GigE
interface.
P
ARAMETERS
None.
D
V
EFAULT
ALUE
None.
P
S
LATFORMS
UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe negotiate
R
H
ELEASE
ISTORY
Release 2.3: command was introduced.
284
Beta
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta