Neighbor - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

NEIGHBOR

neighbor <ip-address> [cost <1-65535>|database-filter all
out|priority <0-255>|poll-interval <0-4294967295>]
D
ESCRIPTION
This command is used in the Router Configuration mode. This command
configures a neighbor router. Use this command only if the network type is 'non-
broadcast'.
P
ARAMETERS
Parameter
ip-address
1-65535
all
0-255
0-4294967295
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-router ospf 30)# neighbor 10.0.0.1 priority 1
poll-interval 130
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Interface IP address of the neighbor.
Assigns a cost to the neighbor, in the form of an integer from
1 to 65535. Neighbors with no specific cost configured will
assume the cost of the interface, based on the 'ip ospf cost'
command. For point-to-multipoint interfaces, the cost
keyword and the number argument are the only options that
are applicable. This keyword does not apply to
nonbroadcast multiaccess (NBMA) networks.
Filters outgoing link-state advertisements (LSAs) to an
OSPF neighbor.
A number that indicates the router priority value of the
nonbroadcast neighbor associated with the IP address
specified. The default is 0. This keyword does not apply to
point-to-multipoint interfaces.
A number value that represents the poll interval time (in
seconds). RFC 1247 recommends that this value be much
larger than the hello interval. The default is 120 seconds (2
minutes). This keyword does not apply to point-to-multipoint
interfaces.
Alcatel-Lucent
Description
Beta
neighbor
475