Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 359

Left running head:
Chapter name (automatic)
Common Classifiers
P
ARAMETERS
1-65535
ip|tcp|udp|igmp|icmp|...
any
host <source ip-address>
interface <interface-
name>
list <name>
prefix <source ip-
address/prefix length>
host <destination ip-
address>
prefix <destination ip-
address/prefix length>
dscp <0-63> <dscp-
mnemonics>
fragment
ip-precedence <0-7>
<precedence-mnemonics>
length {<1-1500>|{eq|ge
|gt|le|lt|range <1-
1500>}
tos <0-15> <tos-
mnemonics>
type {ftp|normal|rpc
|sip|tftp}
icmp-type <0-255> [icmp-
subtype <0-255>]
ack|established|fin|rst|
syn|urg
from <1-65536>
service {<1-
65536>|<protocol>}
326
Beta
Parameter
Alcatel-Lucent
Description
Line/Rule numbers to specify the rule priority.
IP Protocol type, such as UDP, TCP, ICMP, etc.
Indicates a wildcard match. Source being
anything.
Source address.
Name of the interface.
Name of the list.
Source address with prefix length.
Destination address.
Destination address with prefix length.
Denotes the DSCP value.
Used to match an IP fragment.
Specifies the IP Precedence.
Specifies a packet length. Packet lengths can be
expressed as values, a range of values, or other
comparatives such as gt (greater than), lt (less
than) etc.
Specifies IP Type Of Service.
Service type used by the ALGs.
When ICMP is specified as the protocol, the
ICMP type and subtype can be included in the
rule specification. The subtype names available
are dependent upon the ICMP type specified.
Denotes the session state and TCP flags.
Source port for a TCP or UDP protocol.
Destination port for a TCP or UDP protocol.
OmniAccess 700 CLI Command Reference Guide
Beta