Ppp Lcp Max-Echo; Ppp Timeout Restart-Interval - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Point to Point Protocol
-
PPP LCP MAX ECHO
ppp lcp max-echo <0-30>
D
ESCRIPTION
The command is used in the Interface Configuration mode.
This command denotes the maximum number of unanswered LCP echo requests
sent before LCP decides that the peer is down. The value "0" implies that the link
will not be brought down on the basis of unanswered echo requests.
P
ARAMETERS
0-30
D V
EFAULT ALUE
The "no" command sets the maximum number of unanswered LCP echo requests
to is default, i.e., 5.
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp lcp max-echo 20
PPP TIMEOUT RESTART
ppp timeout restart-interval <0-255>
D
ESCRIPTION
The command is used in the Interface Configuration mode. This command
defines the interval after which the LCP/NCP negotiation will be reattempted after
it is terminated.
P
ARAMETERS
0-255
D V
EFAULT ALUE
The default LCP/NCP restart-interval is 30 seconds.
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout restart-interval 10
268
Beta
Parameter
-
INTERVAL
Parameter
Alcatel-Lucent
Description
Denotes the maximum number of unanswered
requests.
Description
Specifies the interval after which the LCP
negotiation will be reattempted after it is
terminated.
OmniAccess 700 CLI Command Reference Guide
Beta