Ip Ospf Dead-Interval; Ip Ospf Flood-Reduction - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
IP OSPF DEAD INTERVAL
ip ospf dead-interval <1-65535>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command sets
the number of seconds that a device must wait before it declares a neighbor
OSPF router down because it has not received a hello packet.
P
ARAMETERS
Parameter
1-65535
D V
EFAULT ALUE
Default value in seconds- Four times the interval set by the 'ip ospf hello-interval'
command. On broadcast network, the dead-interval is 40 seconds.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf dead-interval 50
-
IP OSPF FLOOD

ip ospf flood-reduction

D
ESCRIPTION
This command is used in the Interface Configuration mode. This command is
used to suppress the unnecessary flooding of LSAs in stable topologies.
P
ARAMETERS
None.
D V
EFAULT ALUE
Disabled.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf flood-reduction
OmniAccess 700 CLI Command Reference Guide
Beta
Interval (in seconds) during which the router must receive at
least one hello packet from a neighbor or else that neighbor
is removed from the peer list and does not participate in
routing. The value must be the same for all nodes on the
network.
REDUCTION
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description

ip ospf dead-interval

469
Beta