Ip Ospf Hello-Interval; Ip Ospf Message-Digest-Key - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Open Shortest Path First
-
IP OSPF HELLO INTERVAL
ip ospf hello-interval <1-65535>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
specifies the length of time (in seconds) between the hello packets that OSPF
sends on an interface.
P
ARAMETERS
Parameter
1-65535
D V
EFAULT ALUE
The default hello-interval is 10 seconds.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf hello-interval 20
IP OSPF MESSAGE
ip ospf message-digest-key <1-255> md5 <key>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
enables OSPF MD5 authentication.
The values for the key-id and key arguments must match the values specified for
other neighbors on a network segment.
P
ARAMETERS
Parameter
<1-255>
key
D V
EFAULT ALUE
OSPF MD5 authentication is disabled.
470
Beta
Specifies the interval (in seconds). The value must be the
same for all nodes on a specific network.
- -
DIGEST KEY
Key number in the range from 1 to 255.
The message digest authentication key.
Alcatel-Lucent
Description
Description
OmniAccess 700 CLI Command Reference Guide
Beta